Custom Search



  Buffing Marble

A good buffing marble techniques will leave the floor looking shining and look as if it is wet. Marble surfaces are very beautiful and they are long lasting. Buffing marble is very easy. The floor allows  the pad to gide easily. As the site aim is to waste no time, the  buffing marble tips are very basic and can be used as often as necessary. These are the only efficient floor care method that one needs to keep the marble shining for at least six months. In high traffic areas the floor care must be done daily. A mat should be placed by the entrance. The mat should be vacuumed daily in order not to defeat its purpose of being there.


The Routine steps
Place the warning signs in order to warn that there is work in progress.  The floor has to  be swept with a dust control mop. These are easy to handle and they rest flat on the  surface and collect any unseen fine dust. They do also ensure that large areas are easily and quickly swept. Before starting buffing marble floors, it is good practice to remove the stains. Most stain on marble can be removed with soapy water and a green pad and a gentle scrub. Hand soap is actually sufficient and safe type of soap to use. Acidic liquid should not be used on the floor. An old marble will require the services of a marble specialist company that will polish the floor using either powder or liquid. This is time consuming. The job for the patient person.



Preparation
The best buffing marble system will first of all mop the floor  with a mop which has as less water as possible. This will be enough to clean any marble floor. While mopping, one should not see any trace of water at all on the floor. The mopping is done in a figure of  eight. Before buffing marble surfaces, one has  to make sure that chewing gum  and removable marks are removed off the floor. This will make the surface look clean and allow the buffing machine to slide smoothly. At this point one can already appreciate the beauty of the walkway.


Wire Wool Pad
The buffing machine is the obvious machine for the buffing marble task. Actually, there are two buffing marble systems mostly employed. A white pad or the wired wool can be used.  Buffing marble with wired wool requires a wired wool disc and a heavy  standing buffing machine.  There is also the need of a spray gun filled with a marble floor maintainer.  This means that the slower one moves the buffer the more shine comes out from the surface. Avoid over spraying  the water in order to get an efficient buffing marble result. Too much water on the surface will only lengthen the time it takes to do the task. After buffing, the floor should be vacuumed in order to collect all the debris left by the wired wool.

The White Pad Method
Buffing marble floor with a which uses white pad will provide a shiny floor but a bit less shiny than the wired wool system. The buffer should preferably be heavy or a light standing one. Spray as less water as possible. The surface has to be buff three times in order achieve a good shine. This is the fastest  buffing marble method. It also leaves less debris on the work area.


The two  buffing marble ways are very efficient. The floor has to be looked after regularly. The manufacturer's instructions on the liquid maintainer should be followed. This site regard them as a complement to all the floor care method. There is no secret in buffing marble.